If you’re serious about your car audio system, buying an amplifier is one approach to improve sound quality and power. If you want to minimize distortion and deliver enough energy to power a subwoofer, you’ll need an amplifier. Hifonics specializes in amplifiers, as well as subwoofers, speakers, and soundbars, with the motto “Power From The Gods.” To locate the best Hifonics amplifiers on the market, consult our shopping guide.
Table of Contents
Hifonics BXX3000.1D Brutus Class D 3000W RMS 1 Ohm Mono Car Subwoofer Amplifier
- 3000W RMS 1 Ohm Mono Car Subwoofer Amplifier
- Phase Shift: 0° - 180°
- Signal to Noise - >95dB. Frequency Response - 10Hz - 250Hz. Bass Boost -...
The BXX3000.1D uses Class D amplifier technology to deliver a total of 3000W of power. Even after amplification, this effective method ensures that you obtain high-quality sound.
Hifonics series amps has ensured that the sound quality does not deteriorate when it exits the amplifier. This is why Ultra-Fi MOSFETs were used for the outputs. It ensures that variations in song volume do not cause distortion in your car stereo. You may easily increase the bass intensity with the bass remote and bass knob. Turn the bass remote knob instead of reaching for the amp itself.
The frequency range of the BXX3000.1D is 10Hz to 250Hz. You can use the subsonic filter to eliminate up to 35Hz if your car stereo speakers can’t go that low. It’s also worth highlighting the phase shift feature.
If you use different amps to drive the woofers and tweeters, the sounds may arrive at your ears at various times. Even though the time difference is only milliseconds, there is still a difference in your audio systems. You may correct this with the phase shift controls. This is the best hifonics amp in 2021.
Hifonics BRX1516.1D Brutus 1500W Mono Car Amp
- Ultra-fine mosfets circuit maximizing power efficiency while improving...
- LED power (Green) and protect (Red) indicators
- Manufactured in China
The Brutus BRX1516.1D model amplifier kicks off our Best Hifonics Amp review. This mono-block amp is manufactured from a heavy-duty aluminum alloy. Don’t let the BRX1516.1D amplifier’s modest size fool you into believing it’s not very strong. The highest output of this Brutus amp is 1,500 watts. However, depending on how many ohms your subwoofer draws from the amp, the RMS power will vary.
The Hifonics 1516.1D is a two-input, two-output subwoofer amplifier. It’s 12.5 x 2.4 x 9.8 inches in size. This size should not take up a lot of room in your vehicle. It has a 1500W power rating. However, it can only deliver that much power when you’re using a 1-ohm speaker. If your car employs 4-ohm speakers, they will take just 550W from the amp. Of course, it is dependent on how much bass boost you apply.
The Brutus amp’s control knobs are located on the back end. These knobs are designed to prevent inadvertent turning. We’ll discuss about what these knobs do under sound quality. Furthermore, noise should not be an issue when utilizing this amplifier. Even the quietest sounds should be able to play without being interrupted by noise, thanks to a signal to noise ratio of around 95db.
Hifonics ZEUS ZRX1216.1D Amplifier
- Class D MOSFET Monoblock Amplifier
- Peak Power: 1x3200 @ 1 Ohm, 1x1600 @ 2 Ohms, 1x800 @ 4 Ohms
- Frequency Response: 10Hz-300Hz, Built in bass control with 0-12dB boost
This Zeus amp is a mono subwoofer amplifier in class D. It turns low-level audio signals into bold, powerful music while keeping the temperature within a safe range. It does not get as hot as other amp types. In addition, among all the amp classes, Class D is the most efficient. It produces a loud sound without sacrificing quality.
ZRX1216 measures 12.6 x 2.4 x 10 inches. The connection is established via RCA input and output ports at the rear of the amp. This amp delivers 1200W per 1-ohm speaker in terms of power. This means that a 4-ohm car speaker can handle up to 400W of power. For most automobile woofers, this is usually sufficient. The ZRX1216.1D is a mono amp, even if you use more than one channel. This means that stereo separation is not possible. Because it’s a subwoofer amp, this shouldn’t be an issue. You’re almost certainly not going to play a music with stereo subsonic frequencies.
The frequency range of the Hifonics ZRX1216.1D Zeus Amplifier is 10Hz to 300Hz. It’s a little range in general, but it’s a lot for a subwoofer amp. Also, if you’re using connecting cables, check sure they’re in good condition. You shouldn’t have noise difficulties with this system. It has a 95db signal-to-noise ratio. It also has a reasonable overall harmonic distortion level: 0.1 percent . This allows for a powerful sound without sacrificing quality.
Despite the fact that these specifications indicate high-quality sound, the speakers you utilize with the amp are just as significant. If you use this amp with weak speakers, your car radio will still sound mediocre.
Hifonics Brutus Gamma BG Series (BG-1900.1D)
- Class D MOSFET Monoblock Amplifier
- Peak Power: 1x1900 @ 1 Ohm, 1x950 @ 2 Ohms, 1x475 @ 4 Ohms
- Frequency Response: 10Hz-500Hz, Built in bass control with 0-10dB boost
They include all of Hifonics’ most cutting-edge technologies at an affordable price. To name a few features, the BG-1900.1D has Ultra-FiTM MOSFET outputs for greater balance and power, as well as a dual-coil power supply.
At 1 ohm, this amp has a peak power of 1900 watts. Even at 4-ohms, the power output is a fairly dependable 475 watts. Because the power output is so consistent, you won’t have any trouble connecting this amp to two subwoofers. With this amplifier, you’ll get a square remote bass controller. It has a little knob that allows you to fine-tune the bass output without having to go into the settings of your system. A metal bracket runs down the bottom of the control module, allowing you to attach it in a convenient spot.
The subsonic, phase, LPF, and bass equalization knobs on the side of the amplifier can be used to fine-tune the output even more. The bass equalizer adjustments can increase the output by up to ten decibels, allowing you to fully feel the bass.
Hifonics ZRX1816.1D Zeus Mono Class-D Subwoofer Amplifier
- Illuminated Hifonics Badge
- SPC - Simpatico Coil Design, HSMD - Hifonics Surface Mount Design
- PWM MOSFET Power Supply for Maximum Current Levels
The ZRX1816.1D is a mono output amplifier that can deliver up to 1800W of power to your automobile sound system. 4-ohm speakers, on the other hand, will only draw 500W, which is all they need to start blasting. Even though it only has a mono output, if you have many channels, you can be guaranteed that all of the speakers will produce the same bass frequency.
In fact, for any system dedicated to bass creation, mono is preferable to stereo. This is because most audio producers keep everything below 400Hz in mono during the music production process. This means you’re not missing out on anything if your woofer amp doesn’t offer stereo output.
This amp provides more than enough space for a powerful sound. The bass boost control allows you to increase the bass-heavy sound by up to 12db. You shouldn’t need to turn the bass boost all the way up unless you’re DJing from the trunk of your car. This amp is the perfect automobile audio gear for bassheads, with a frequency response of 10Hz to 300Hz. All you need to do now is acquire the appropriate speakers.
Hifonics BXX2000.1D Brutus Class D 2000W RMS 1 Ohm Mono Car Subwoofer Amplifier
- 1 Ohm Mono Car Subwoofer Amplifier
Made using super class D technology is the BXX2000.1D. Aside from the advantages already mentioned, Class D amplifiers will help you conserve some energy from your car’s battery. It makes judicious use of power. Rather than utilizing a constant quantity of energy, the consumption decreases when the music is quieter and increases when the music is more energetic.
The 2000W power that this amp offers drives the frequency range of 10Hz to 250Hz. Depending on your speaker specifications, you can change the sound production. The variable low pass crossover and subsonic filter knobs allow you more control over the sound you want from your woofers. Even at high volumes, this amp produces clear sounds with no apparent distortion.
Hifonics ZXX-3200.1D Zeus Mono Channel Car Audio Amplifier
- Class D MOSFET Monoblock Amplifier
- Peak Power: 1x3200 @ 1 Ohm, 1x1600 @ 2 Ohms, 1x800 @ 4 Ohms
- Frequency Response: 10Hz-300Hz, Built in bass control with 0-12dB boost
The ZXX-3200 has a lot of power available. One D amp has no trouble driving two or even four subs. It has an 800 watt power even at 4-ohms. In addition, you can daisy chain this to another amp using the available RCA outputs if 3200 watts isn’t enough power for the pulse width.
No matter what subwoofer’s impedance you connect it to, you’ll discover power output is generally consistent across hifonic amps. However, because it consumes so much power, you might want to think about connecting it to a different battery. This amp requires 2-gauge wiring as opposed to most of the other amps we’ve looked at, which need 4-gauge. Additionally, 12-gauge wires are required to connect your speakers.
Given that this is a Hifonics amplifier, the settings to change the gain and phase are conventional. But there are no bass-specific equalizer options to change the width, bass frequencies, center, or boost levels or system diagnostics.
Hifonics Zeus (ZG-1200.1D)
- Angled Terminals for Ease of Access
- 1,200 watts max
- 600 watts x 1 at 2 ohms
With a weight of just over 8 pounds, the ZG-1220.1D is also the lightest amplifier in this review. You may easily place the amp on the side of your subwoofer box due to its tiny size and low weight. This amplifier has many characteristics with its bigger brother, the Zeus ZG-1800.1D we just examined. The ZG-1200.1D has the same connectors and controls as the ZG-1200.1 and is constructed of the same aluminum.
The amount of power it produces overall makes the most difference. At 1 ohm, the ZG-1200.1D delivers a steady 1200 watts. You will get 600 watts at 2 ohms and 300 watts at 4 ohms. During testing, this amplifier functioned remarkably well. The rated output of this amplifier is essentially accurate, however at very high volumes, harmonic distortion might be present.
We also found that the super d amp is so little that you might have trouble setting the on-board electronic equalizer.
Frequently Asked Questions
Are Hifonics Amps good?
Yes.
How many channels should my amp have?
What you want your audio system to do is up to you. An amplifier’s channels each power one speaker. For powering a single pair of speakers, a two-channel amplifier is sufficient. A four-channel amp, on the other hand, will work better if you want rear-fill sound as well as front-to-back fade control. A single pair of speakers plus a subwoofer can be powered by a three-channel amplifier.
How much power does my car audio system require?
A small-cab pickup, hatchback, sports car, or compact automobile can benefit from an amplifier with 50 watts RMS per channel to reduce road noise and improve sound clarity. Look for a device that is at least 75 watts RMS per channel if you have a bigger car or just want additional loudness. You can obtain 100 watts RMS or more per channel if you play your music incredibly loud.